2. Production Tolerances 生产公差
To ensure continuity of the fit, Sapph requires the following production tolerances.
Production Tolerances - Bra
Measurement Section
| Production Tolerance ( ± cm)
|
A | Underbust length to 1st hook (straight)
| 1 |
B | Upper back length (excl. Wire casing/H&E)
| 0.5 |
C | Bottom back length (excl. Hook)
| 0.5 |
| Side height
| 0.3 |
| Hook & Eye width
| 0.3 |
| Numbers of hook & eye
| 0 |
D | Front neck length (incl. wire casing) = cup edge length | 0.5 |
| Overbust length (incl. wire casing)
| 0.5 |
J | Cup height (incl. Wire casing)
| 0.5 |
L | Armhole length (incl. Wire casing)
| 0.3 |
| Wire length
| 0.2 |
F | Center front upper width (excl. Wire casing)
| 0.2 |
G | Wire play to bartack ( note 1)
| 0.5 |
H | Center front height
| 0.3 |
E | Shoulder strap back length (adjust 5 cm)
| 0.5 |
I | Front strap length
| 0.5 |
| Shoulder strap width
| 0 |
| Distance metal label to cup
| 0.5
|
Note 1) The wire has to fill the tunnel of the wire until the side of the bra. There has to be 5 mm space between the end of t